© 2024 Jasper van Baten, AmsterCHEM

REFPROP CAPE-OPEN LICENSE
Version 1
Copyright (C) 2023, Jasper van Baten / AmsterCHEM

This software can be used for free for a trial period of 7 days. If you want to continue using this software, you must pay a fee. You can freely distribute this Program and its components provided that the complete distribution is copied without modifications and the redistribution will be free of charge.

You may not modify your copy or copies of the Program and its components.

You may not copy, modify, sublicense, or distribute the Program and its components except as expressly provided under this License. Any attempt otherwise to copy, modify, sublicense or distribute the Program and its components is void, and will automatically terminate your rights under this License.

You are not required to accept this License, since you have not signed it. However, nothing else grants you permission to modify or distribute the Program or its derivative works. These actions are prohibited by law if you do not accept this License. Therefore, by distributing the Program and its components, you indicate your acceptance of this License to do so, and all its terms and conditions for copying or distributing the Program and its components.

During operation of the Program, a registration dialog will be shown if the Program has not yet been registered. Before registration, you can freely evaluate this Program for a limited amount of time of 7 days. If you continue to use this program after its evaluation period, you must register. Registration will grant you the right to use this Program commercially or privately. Registration is on a per-person basis, the registered person has the right to use this Program on multiple computers for an unlimited period.

Before registering, please make sure that you have evaluated the Program and the Program does what you expect it to do. To register this Program, please contact


   info@amsterchem.com

For any use of this Program not covered by this license agreement, please contact


   info@amsterchem.com

NO WARRANTY

THERE IS NO WARRANTY FOR THE PROGRAM AND ITS COMPONENTS, TO THE EXTENT PERMITTED BY APPLICABLE LAW. THE PROGRAM AND ITS COMPONENTS ARE "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM AND ITS COMPONENTS IS WITH YOU. SHOULD THE PROGRAM OR ONE OF ITS COMPONENTS PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION.

IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY REDISTRIBUTE THE PROGRAM AND ITS COMPONENTS AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PROGRAM OR ITS COMPONENTS (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE PROGRAM TO OPERATE WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

END OF TERMS AND CONDITIONS

INDEX
Calculation methods
CAPE-OPEN
COM registration
Compound constants
Configuring Property Packages
Copyright
Disclaimer
Editing Property Packages
Flash calculations
Fluid files
Getting started
License
Mixture coefficients
Mixture properties
Property derivatives
Property Package files
Single-phase properties
Supported properties
Temperature dependent properties
Two-phase properties
User data
Version
Welcome
CONTENT
 Welcome
 Getting started
 Configuring Property Packages
 Supported calculations
 License